Welcome, Guest
Username: Password: Remember me

TOPIC: porcelain, so as to avoid the uneven heating

porcelain, so as to avoid the uneven heating 2 months 3 days ago #4431

  • qizhen111
  • qizhen111's Avatar
  • Offline
  • Platinum Member
  • Posts: 680
  • Karma: 0
<p>should be used step by step in the first time. When using the geothermal floor, consumers must pay attention to heating the floor and floor step by step. When installed, the surface temperature should be kept at about 18 degrees celsius. Before installation, gradually increase the temperature of the cement ground, increase by 5 degrees per day until the standard of about 18 degrees celsius. In the first 3 days after the installation, continue to maintain the </p>
<p>temperature, 3 days after the warming up according to the needs, and can only be increased by 5 degrees per day. The first use of geothermal heating, attention should be slowly warming. For the first time, three days before the beginning of heating, the temperature should gradually rise: the first day of water temperature of 18 degrees, second days, 25 degrees, third days, 30 degrees, fourth days can rise to normal temperature, that is, the temperature of 45 </p>
<p>degrees, the surface temperature of 28 ~ 30 degrees. If you don't heat up too fast, the floor may crack and twist because of expansion. After a long period of time, the geothermal heating system should be used again, and it should be heated in accordance with the heating procedure as it was for the first time. Two, the surface temperature is not too high to note is that the use of geothermal heating, the surface temperature should not exceed 28 degrees, the water </p>
<p>24 square meters of wood decking<br />
okoume marine plywood in Hong Kong<br />
installing tongue and groove composite decking</p>
The administrator has disabled public write access.
Time to create page: 0.071 seconds
Powered by Kunena Forum